Náhradná tryska pre hotendy od E3D. Priemer trysky 0.15mm je určený pre detailné tlač. S touto tryskou budete tlačiť kvalitne aj jemné detaily. Pri zachovaní kvality tlače odporúčame znížiť rýchlosť.

Vnútorná geometria trysky je optimalizovaná pre zníženie protitlaku, čo zaisťuje hladký a ľahký pohyb filamentu a retrakcii. Spodná plochý povrch zrovná vrstvu.

Materiál: mosadz

Závit: M6

Priemer trysky: 0,15 mm

Tryska možno použiť v hotendech od E3D - v4, v5, v6, lite6 a Kraken.

Slicer settings

Extruder

• Nozzle Diameter: 0.15mm
• Extrusion Multiplier: 1.00
• Extrusion Width: 0.18mm
• Layer Height: 0.0800mm
• Retraction Distance: 1.00mm
• Extra Retraction Distance: 0.00mm
• Retraction Vertical Lift: 0.00mm (important to reduce vibration and vertical stringing)
• Retraction Speed: 30.0mm.s-1
• No Coasting
• No Wiping

Layers

• 3 layers top, bottom and sides printed inside out
• First Layer Height: 160%
• First Layer Width: 120%
• First Layer Speed: 50%

Infill

• Triangular Infill (0, 60, -60)
• Interior Fill Percentage: 25%
• Outline Overlap: 15%
• Infill Extrusion Width: 100%
• Minimum Infill Length: 5.00mm (can be less due to the good bridging capabilities)
• Print sparse infill every layer

Support (if required)

• Support Infill Percentage: 30%
• No extra inflation distance
• No dense support layers
• Support every layer
• Horizontal Offset From Part: 0.30mm
• Upper Vertical Separation: 1 layer
• Lower Vertical Separation: 1 layer
• Max Overhang: 45 deg

Speeds

• Default Printing Speed: 30.0mm.s-1
• Outline Underspeed: 75%
• Solid Infill Underspeed: 80%
• Support Structure Underspeed: 80%
• X/Y Axis Speed: 80mm.s-1
• Z Axis Speed: 16.7mm.s-1